This should be performed on both the device types (G.L.O.V.E. & E-BAND) when the time changes


E-Band stores the time on the remote, not the band. Enter "7, 8, 9, OK" on the remote and then follow the steps below.


1. Log into the software

2. Establish a USB data connection and power on the device

3. Navigate to the Set Clock tab

4. Click "Establish COMMS"

5. Verify the Serial Number on the screen matches the connected device

6. Select "Use Computer Time" 

7. Click "Sync Device Clock"


The device clock will now match the clock shown in the lower right hand corner of your computer screen.